You may move Graph 'n Calc (Desk Top Computer Software Inc.) to the hard disk.
This will allow you to access it with greater ease than using floppy disks.
These instructions assume you are moving Graph 'n' Calc to a ProFile (with a
driver name .PROFILE). Substitute the name of your hard disk driver for
".PROFILE" if you wish to install Graph 'n' Calc on a different hard disk.
COPY PROCEDURE
1. Boot the CATALYST diskette (if you haven't already).
2. From the main CATALYST menu, select the Systems Utilities Program.
3. Press "F" for File Handling Commands.
4. Press "M" for Make a New Subdirectory.
5. Enter ".PROFILE/GNC".
6. Press RETURN to accept the default size of 25 files.
7. Press ESCAPE.
8. Put the Graph'n' Calc "GNC1" diskette in the internal drive.
9. Press "C" to copy files.
10. Copy all files from your "GNC1" disk to ".PROFILE/GNC/=" except for the
following:
SOS.KERNEL SOS.INTERP SOS.DRIVER
To do this, type ".D1" and press the up arrow key. A list of files are
displayed in a box. The up and down arrow keys allow you to move an inverse bar
over the name of your choice. Pressing the right arrow key marks the file so as
to include it in the copy process. Mark all files to be copied in this way.
When all files are marked, press RETURN.
11. Copy all files from "GNC2" to the same subdirectory using the procedure
above.
12. When all files have been copied, Press ESCAPE.
ADDING GRAPH 'N' CALC TO THE CATALYST MENU
1. Return to the Catalyst main menu.
2. Select the Catalyst Editor.
3. Enter "E" to edit the menu.
4. Use the up and down arrow keys to position the inverse bar over the entry
you want the program to precede. Press "A" to ADD a program entry.
5. You will be asked for the display name of this program, enter "GNC".
6. Enter "CATALYST/BASIC as the interpreter path name.
7. You will be asked if you want "EXTRA DRIVERS", enter ".GRAFIX"
8. Press RETURN for standard character set.
9. Press RETURN for the normal screen.
10. Press RETURN for the default keyboard.
11. Enter ".PROFILE/GNC" initial prefix.
12. Enter "0" for the "Max Files Allowed..." question.
13. Enter ".PROFILE/GNC/HELLO for the program path.
14. You will be asked if this entry is correct. If it is, enter "Y" then press
ESCAPE to exit to the main edit menu. If you made any mistakes during entry,
enter "N". You may then enter the number of the item you wish to correct. When
all items are correct, press ESCAPE. Press ESCAPE again to exit to the main
edit menu.
15. Enter "5" to update the INTERPS file. When you are asked if you want to
recalculate the load address, enter "N".
16. Exit to the Catalyst main menu by entering "Q".
NOTE: Apple Computer Inc. is not responsible for the contents of this
article.