You may move DataFax (Link Systems) to a hard disk for use with Catalyst. These
instructions assume you are moving DataFax to a ProFile (with driver name
.PROFILE). Substitute the name of your hard disk driver for .PROFILE if you
wish to install DataFax on a different hard disk.
COPY PROCEDURE:
1. Boot the Catalyst diskette (if you haven't already).
2. From the Catalyst main menu, select the System Utilities Program.
3. Enter "F" for FILE HANDLING COMMANDS.
4. Enter "M" for MAKE A NEW SUBDIRECTORY.
5. Enter "CATALYST/DATAFAX" with a default size of 25 files.
6. Press "ESCAPE".
7. Enter "C" for COPY FILES.
8. Copy all files from the PROGRAM disk to the subdirectory
"CATALYST/DATAFAX/=" except for the following:
SYSTEM.MISCINFO SYSTEM.PASCAL
To do this, type ".D1/" and press the up arrow key. A list of files are
displayed in a box. The up and down arrow keys allow you to move an inverse bar
over the name of your choice. Pressing the right arrow key marks the file so as
to include it in the copy process. Mark all files to be copied in this way.
When all files are marked, press RETURN.
9. When all files have been copied, press ESCAPE.
ADDING DATAFAX TO THE CATALYST MENU
1. Return to the Catalyst main menu.
2. Select the Catalyst Editor.
3. Enter "E" to edit the menu.
4. Use the up and down arrow keys to position the inverse bar over the entry
you want the program to precede. Press "A" to ADD a program entry.
5. You will be asked for the display name of this program, enter "DATAFAX".
6. Enter "CATALYST/PASCAL" as the interpreter path name.
7. You will be asked if you want "EXTRA DRIVERS". See page 3-9 of the
Catalyst
manual for input instructions.
8. Press RETURN for standard character set.
9. Press RETURN for the normal screen.
10. Press RETURN for the default keyboard.
11. Press RETURN for initial prefix.
12. Enter "3" for the "Max Files Allowed..." question.
13. Enter "CATALYST/DATAFAX/SYSTEM.STARTUP" program path.
14. You will be asked if this entry is correct. If it is, enter "Y" then press
ESCAPE to exit to the main edit menu. If you made any mistakes during entry,
enter "N". You may then enter the number of the item you wish to correct. When
all items are correct, press ESCAPE. Press ESCAPE again to exit to the main
edit menu.
15. Enter "5" to update the INTERPS file. When you are asked if you want to
recalculate the load address, enter "Y".
16. Exit to the Catalyst main menu by entering "Q".
NOTE: Apple Computer Inc. is not responsible for the contents of this
article.