Configuring the ImageWriter to an Apple III or III+ (10/94)

Configuring the ImageWriter to an Apple III or III+ (10/94)

The following information shows how to configure an Apple /// and an ImageWriter II printer.
Interface:
 
  You may use either the .PRINTER driver or the .RS232 driver. The
  appropriate data configuration blocks for these drivers are:
 
    .PRINTER:  [0E] [00] [00] [00] [00]
    .RS232:    [0E] [00] [00] [00] [00] [00] [13] [11] [DF] [84] [50] [80]
 
Cables:
 
   Modem Eliminator Cable (Part #590-0166)
   Serial and Communications Cable (Part #590-0037)
  
Printer Switch Settings:
 
          8 7 6 5 4 3 2 1
    SW1: | | |X| | | | | |
         |X|X| |X|X|X|X|X|
 
                  4 3 2 1
    SW2:         | | |X|X|
                 |X|X| | |
 
    NOTE: These switch settings are for the U.S. character set, 66-line
          page length, 8 data bits, elite pitch, no auto-LF after CR,
          9600 baud, DTR data protocol. If you wish to change any of these
          settings, you must make corresponding changes in the data
          configuration block for whatever printer driver you're using. 
 
Search on "Imagewriter and switches" and/or "driver data configuration" for
more information on configuring.


Article Change History:
17 Oct 1994 - Reviewed for technical accuracy, revised formatting.

Support Information Services

Back